MiniMondoMayhem
3D modeler,
Designer,
Product designer
Bad boys whacha gondo http://shpws.me/Rt6Z
bdbrigman2015
Could these be scaled down to 1/60 (diaclone reboot) scale?
October 2, 2020
Many people asked for these two shells, they are here! http://shpws.me/R1YY
MiniMondoMayhem @jonathonrod
Have you tried BBTS. He is not the rarest of shells to find. Good luck.
MiniMondoMayhem Wave3 is up now! https://www.shapeways.com/product/AM6QTF4YJ/primemasterweaponswave3?optionId=66446871&li=shop-inventory
MiniMondoMayhem Hi, thanks a lot, much appreciated! Wave3 - the set you mention has the test print coming in tomorrow. So all being well i hope it goes up very soon.
MiniMondoMayhem @xXBKARXx
Sadly the cost on doing the back would see the cost balloon, think paying 20usd each, for each back which would be inferior to factory produced shell.
MiniMondoMayhem @Ashtonmcvae@Ashtonmcvae@Ashtonmcvae@Ashtonmcvae
Coming at the end of this month.
Bulgy is here, more to come for december! http://shpws.me/QR8X
(Edited)
(Edited)
MiniMondoMayhem @fb04d10 i will do the backpacks for the 3rd wave however i shifted focus off them because they seemed less populer. Give me a few days this week i think i will get them up. Sorry, thanks.
My first transforming figure! A bit of hard work has gone into this guy. After a bit hard work on the Primemaster sets. And still lots more to come... http://shpws.me/Qpfl
(Edited)
(Edited)
MiniMondoMayhem Hi Xenock. Thanks for the purchase! And huge apology for the late reply, my head is out of shapeways for months+ sometimes. I did enable the ultra detail now. I keep meaning to upload photos of my test and approved prints so buyers can compare what i deemed acceptable, because each print can vary in quality i have found. And of course each material can be grainy, WSF particulary.
It has been along time since posted, but thank you and apologies.
