Home » Support » 3D Design » Making a hole in Meshlab
Search Search  
Making a hole in Meshlab [message #50030] Tue, 19 June 2012 17:17 UTC Go to previous message
avatar ASCPhotos&Designs is currently offline ASCPhotos&Designs
Messages: 6
Registered: June 2012
Go to my shop
Junior Member
I hope this is the right place to put this question out there.

I made a sculpture in Scuptris then Imported it into MeshLab to paint and export as .WRL. When I uploaded the sculpture it came out to be around $80!

I go to looking into the pricing and found that if I make it hallow that will help.

So here's my dilemma. I really don't want to have to repaint it all over again, but I don't know how to make a hole in the top of it in MeshLab. So if you can tell me how to accomplish this I would GREATLY appreciate it!

Thanks for your time, ASC
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Not attached?
Next Topic:AutoDesk Problems
Goto Forum:
   Go
Generate printable PDF   


Current Time: Sun May 19 14:35:14 UTC 2013