Home » Community » 3D modeler needed » Scaling Up Models
Search Search  
Scaling Up Models [message #49728] Tue, 12 June 2012 08:11 UTC Go to previous message
avatar TheJrade  is currently offline TheJrade
Messages: 5
Registered: June 2012
Go to all my models
Junior Member
I have found some models that I would like to buy, specifically:
http://www.shapeways.com/model/82824/xuvaxi-enforcer.html

But would like to have some of the models made slightly larger, I have contacted the designer but haven't received a response (yet?). My question is how difficult is this to do? If I don't receive word from the modeler, can anyone else do a similar model in a larger size? I would be looking to purchase about 20 models to the tune of about $200 if that is any motivator.

Thanks in Advance,
Jared

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Need C4D model ready for 3D printing.
Next Topic:Bushings from 1/2" to M12 (12mm)
Goto Forum:
   Go