Home » Community » General Discussion » pricing inconsistency??
Search Search  
pricing inconsistency?? [message #49304] Fri, 01 June 2012 19:04 UTC Go to previous message
avatar michaelzindell9246 is currently offline michaelzindell9246
Messages: 5
Registered: January 2010
Go to my shop
Junior Member
I havent used shapeways in while, but today I uploaded some parts to get a rough estimate on a new project. I was going to have my project printed in sandstone (no color).

when I uploaded my 4 parts, the sandstone costs are Higher than STW, even though the material page says that sandstone should be about half the cost (.75 per CM3 for sandstone compared to 1.40 per CM3 for STF)

is this a glitch? or does pricing change for other reasons?


Michael
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Frequency of 3D printer upgrades
Next Topic:Color print problems
Goto Forum:
   Go
Generate printable PDF   


Current Time: Tue May 21 05:09:49 UTC 2013