Home » Support » 3D Printing » What's your most brittle material?
Search Search  
What's your most brittle material? [message #47930] Sat, 05 May 2012 14:10 UTC Go to previous message
avatar Mick Lang  is currently offline Mick Lang
Messages: 23
Registered: September 2008
Go to all my models
Junior Member
This will probably sound bizarre, but what's your most brittle material? Can I print a very thin mesh or coil from it? I need it about as fragile as a christmas tree glass ball.

Thanks!

Mick

Read Message
Read Message
Read Message
Previous Topic:Stainless Pass/Fail design help needed
Next Topic:Stainless Steal min. hole?
Goto Forum:
   Go