Home » Community » Introductions » Hey
Search Search  
Hey [message #34759] Wed, 21 September 2011 04:15 UTC Go to previous message
avatar afein10 is currently offline afein10
Messages: 2
Registered: March 2011
Go to my shop
Junior Member
Hi guys,

I'm pretty new to 3d designing, just doing it as a hobby. I do most of my work on Google Sketchup - any suggestions for better software?

I've designed a ring that has a groove with a ball that can roll around freely inside (somewhat similar to TerraCotta's design: http://www.shapeways.com/model/52936/). I've had problems before where smaller parts of my design either don't print at all, or get lost in the printing. Would a ball with a diameter of 1mm print (if inclosed in the ring)?

Also, I would like to print it in stainless steel, but would that work?

Best Regards,
Andrew
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Previous Topic:Greetings
Next Topic:heyo
Goto Forum:
   Go
Generate printable PDF   


Current Time: Mon May 20 04:28:39 UTC 2013