Home » Support » 3D Design » Lost Details in FUD
Search Search  
Lost Details in FUD [message #34631] Tue, 20 September 2011 06:11 UTC Go to previous message
avatar Scout_II@hotmail.com is currently offline Scout_II@hotmail.com
Messages: 13
Registered: January 2011
Go to my shop
Junior Member
Not quite sure where this should be posted, but since in the end it is a design question - this seems as good a place as any.

Basically, I have an object which I had printed. The object has a mostly flat surface. However at various locations on that surface there are spheres. Each sphere has a diameter of 0.3 mm and it is sunk half way into the surface (so that 0.15 mm protrude from the surface).

When I had the object printed most of these spheres seem to have not printed. Some did, however it seems that there really isn't a specific reason why a particular sphere printed while a different did not.

What size does a detail actually have to be in order to be printed reliably every time in FUD?
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Problems with "Hollowing Out" a model to save money
Next Topic:Filled Windows
Goto Forum:
   Go
Generate printable PDF   


Current Time: Wed May 22 10:37:51 UTC 2013