Home » Support » 3D Printing » Stainless Steel specs
Search Search  
Stainless Steel specs [message #33950] Wed, 07 September 2011 17:08 UTC Go to previous message
avatar GuyInLogan is currently offline GuyInLogan
Messages: 2
Registered: August 2011
Go to all my models
Junior Member
I'm having a hard time finding out if this has been resolved, but I haven't seen much more specific guidance on walls and details for stainless steel.

The materials page says 1 mm for details and 3 mm for walls. 3 mm especially seems a bit large, especially for a ring, which I am creating.

Another page in the forums says "it depends."

Is there additional guidance?
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Size misprint 43mm => 41.6mm
Next Topic:Prehistoric Pictograph Printing Tutorial
Goto Forum:
   Go
Generate printable PDF   


Current Time: Tue May 21 19:43:22 UTC 2013