Home » Support » 3D Design » Wall thickness
Search Search  
Wall thickness [message #32850] Wed, 17 August 2011 15:35 UTC Go to previous message
avatar Camazine  is currently offline Camazine
Messages: 34
Registered: July 2011
Go to my shop
Member
I have had a few of my designs fail in the printing process because there were areas where the walls were too thin. I have seen a few posts showing images of wall thickness measurements.

What software programs allow you to measure wall thickness? (I have downloaded the free versions of MeshLab and Netfabb, but have not been able to figure out how to measure wall thickness with them).

An example file and image are attached. It looks as if this object is very thin.

Thanks

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:sizing issue , with flyaway parts
Next Topic:I made a 3d design in c4d but can't upload it
Goto Forum:
   Go