Home » Community » General Discussion » Makers marks, hallmarks
Search Search  
Makers marks, hallmarks [message #31420] Sat, 23 July 2011 23:23 UTC Go to previous message
avatar Tigermoth  is currently offline Tigermoth
Messages: 41
Registered: July 2011
Go to my shop
Member
Hi guys, wondering how many of you who use SW to make jewellery factor in your own makers marks or even hallmarks ( eg: 925 for s/silver) into your designs?

I have been reading up on the minimum detail on the various materials and it seems that 0.3mm is the smallest in s/silver and FUD.
This doesnt sound like much, but even after resizing a 925 stamp so the width of each line is 0.3, its still too large to fit on the inside of a small ring shank for instance.
It does mention however that FUD CAN have detail as little as 0.1mm. If so, this would make a huge difference inthe overall size of the mark...but how accurate would it be? Would this also apply for silver printing?

Keen to hear your thoughts/ experiences on this subject...

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Silver - 925 stamped
Next Topic:shapeways at wired shop
Goto Forum:
   Go

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.