Home » Support » 3D Design » Inverted normals in mesh
Search Search  
Inverted normals in mesh [message #7214] Sun, 11 October 2009 00:28 UTC Go to previous message
avatar NightmareHero is currently offline NightmareHero
Messages: 1
Registered: October 2009
Go to all my models
Junior Member
I was just told that my mesh has inverted normals even though in appearance in Hexagon and Blender the mesh appeared correct when I exported it from Blender in STL format and imported it again into Blender. Since I'm not to familiar with Blender but I have used it, how do I correct the problem in this program?
Report message to a moderator
Message index

Read Message
Read Message
Previous Topic:Getting started?
Next Topic:Wall thickness check without ordering?
Goto Forum:
   Go
Generate printable PDF   


Current Time: Sat May 25 01:18:25 UTC 2013