Home » Support » 3D Design » Walls too thin?
Search Search  
Walls too thin? [message #6229] Wed, 02 September 2009 11:19 UTC Go to previous message
avatar SeveQ is currently offline SeveQ
Messages: 16
Registered: June 2009
Go to my shop
Junior Member
Hi there,

I'm still trying to create this double DIN adapter. Since it is much too expensive I'm trying to make it hollow. A file says a thousand words.

I get the following error message:

Quote:


We could not determine the size and/or volume of your model due to an invalid model structure. Please investigate the problem and try again.



I guess the walls are too thin. But my software says they are more than 2mm everywhere. I'd absolutely appreciate it if someone could investigate this issue... again.

Thanks!

Hendrik

[Updated on: Wed, 02 September 2009 11:39 UTC]

Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Parts Not Attached
Next Topic:loft spline created from poly?
Goto Forum:
   Go
Generate printable PDF   


Current Time: Tue Jun 18 07:37:40 UTC 2013