Home » Community » 3D modeler needed » Need simple 2 piece, threaded container made
Search Search  
Need simple 2 piece, threaded container made [message #61798] Mon, 11 February 2013 16:07 UTC Go to previous message
avatar bforutan is currently offline bforutan
Messages: 3
Registered: February 2013
Go to all my models
Junior Member
Hi guys,

I need the image below made. It consists of two pieces, which can be screwed together using 4 rather large threads. It does not have to be water or air tight. If you can print it for me, all the better. I live in San Diego, Ca. my email is indiesrule@yahoo.com if you wanted to contact directly. I need this by end of the week, if not sooner, please.

index.php?t=getfile&id=27067&private=0

Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Power Ranger Movie figure and Batman Buckle/Pouch
Next Topic:1:64 Railway Equipment
Goto Forum:
   Go
Generate printable PDF   


Current Time: Fri May 24 14:32:12 UTC 2013