Home » Support » 3D Design » Designing for ceramic
Search Search  
Designing for ceramic [message #60894] Sun, 27 January 2013 14:31 UTC Go to previous message
avatar stop4stuff  is currently offline stop4stuff
Messages: 2991
Registered: June 2010
Go to my shop
Senior Member
I'm converting a model from a 12mm tall version I created for another project to be a 5cm tall ornament to be printed in ceramic.

The 5cm scaled up model is at http://shpws.me/ndfJ

There's some detail that's smaller than the design guidleines recommend, and there's some sharp corners.

Would I get away with keeping the internal corners the same and making the external corners (in red) just slightly rounded - maybe 0,5mm radius?



  • Attachment: corners.JPG
    (Size: 26.20KB, Downloaded 81 time(s))

Read Message
Read Message
Read Message
Previous Topic:V-Ray for Rhino Materials? Rendering Advice?
Next Topic:Can't get my design in Ceramic option....
Goto Forum: