Home » Community » It arrived! » First 3d print - light switch plate
Search Search  
First 3d print - light switch plate [message #60245] Tue, 15 January 2013 05:34 UTC Go to previous message
avatar RogerN is currently offline RogerN
Messages: 6
Registered: December 2012
Go to all my models
Junior Member
I was very pleased to receive the results of my first stab at 3d printing. For some reason the concept just excites me. At first I couldn't decide what I wanted to print... then I got the idea to design a custom light switch plate for our downstairs bathroom. The room already has an Asian theme as it contains some souvenirs time spent in China.

IMO it came out great, though I admit I have pretty low standards for this sort of thing, as I'm more of a geek than an artist Smile

Alas, there's a small gap at the left edge of the light switch plate where it doesn't quite cover the hole for the switches... not sure what I'll do about that, if anything. It's my own fault for not measuring the hole behind the original switch plate more closely.

The unpainted light switch plate (2 parts):
index.php?t=getfile&id=25600&private=0

Drying:
index.php?t=getfile&id=25601&private=0

Finally installed:
index.php?t=getfile&id=25602&private=0

Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Polo Shift by ALEX and OSKAR
Next Topic:Sierpinski tetrahedron of Love...
Goto Forum:
   Go
Generate printable PDF   


Current Time: Sat May 25 12:06:02 UTC 2013