Home » Community » General Discussion » Printing height with White Strong and Flexible
Search Search  
Printing height with White Strong and Flexible [message #59843] Tue, 08 January 2013 17:33 UTC Go to previous message
avatar DavidTsai is currently offline DavidTsai
Messages: 8
Registered: July 2008
Go to my shop
Junior Member
I got the material sample and noticed that with the White Strong and Flexible, the height of the diagram is 1.1 mm, however the actual is 1.35. Does the height always print higher by .25 consistently? Also, a side dimensioned as 10 was in reality 9.85.

Is there a consistency in printing larger or smaller in certain directions/orientations?

Thanks
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Previous Topic:SEO
Next Topic:$30 egg holder
Goto Forum:
   Go
Generate printable PDF