Home » Community » General Discussion » embedding magnets
Search Search  
embedding magnets [message #59620] Fri, 04 January 2013 17:48 UTC Go to previous message
avatar kcpenner  is currently offline kcpenner
Messages: 1
Registered: August 2012
Go to all my models
Junior Member
I want to print a working prototype of an item that will eventually be mass-produced, made of molded plastic.

My main question: is it possible for the printing process to be stopped part of the way through for magnets to be placed in a trench in the model, then the printing would continue until the magnets are completely covered? Or should I just model 2 parts that can be glued together later with the magnet inside?

I have not modeled the item yet ...

Read Message
Read Message
Read Message
Previous Topic:Up! Mini vs Stuffmaker 3D Creator
Next Topic:I have a .eps file - do I need to convert it to get a print
Goto Forum:
   Go