Home » Community » Work in progress » Spanish Chiminea tea light holder
Search Search  
Spanish Chiminea tea light holder [message #56914] Thu, 15 November 2012 20:38 UTC Go to previous message
avatar AaronOxenham  is currently offline AaronOxenham
Messages: 6
Registered: October 2012
Go to my shop
Junior Member
Just trying out shapeways, so have started with something basic.

I have designed a Spanish chiminea tea light holder and was just wondering what thickness I should print it?

(an electric tea light would be put inside)

Do you think this would be ok to have a real tea light inside?

I have just been doing some testing with some nylon and a tea light flame. Placing the nylon along the same profile as the chiminea and the nylon gets hot but doesn't melt/wrap. What about use over time as well?

[Updated on: Sat, 17 November 2012 14:45 UTC]

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Advice for beginner
Next Topic:Rabbit Pendant
Goto Forum:
   Go