Home » Community » General Discussion » Wire tests
Search Search  
Wire tests [message #56416] Wed, 07 November 2012 04:56 UTC
avatar Anthromod  is currently offline Anthromod
Messages: 13
Registered: May 2011
Go to my shop
Junior Member
Hi. I'm currently working on a robot hand and I'm interested in if anyone tested the strengths of wires printed in Strong and flexible?

I have a design that uses 4-3mm wires, and a Theo Jansen model that are approx 1.8mm, but that is rather hard to test without breaking. Does anyone have experience using approx 2mm wires, for push/pull uses?

Oh whilst I'm asking, anyone have practical experience of designing living hinges?

Read Message
Previous Topic:Compenetrating geometry?
Next Topic:Dilbert does 3d printing, pure win!!!
Goto Forum:
   Go

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.