Home » Community » General Discussion » Frosted Ultra Detail Silicon Mold
Search Search  
Frosted Ultra Detail Silicon Mold [message #54712] Mon, 01 October 2012 21:03 UTC Go to previous message
avatar cero is currently offline cero
Messages: 2
Registered: March 2011
Go to my shop
Junior Member
Hey everybody,

I'm trying to create some silicon molds of some Frosted Ultra Detail parts I've created and the silicon keeps sticking to the parts. It's like their too porous. Has anyone done this before? Any suggestions? I'm using the Smooth-on OOMOO 30 and OOMOO 25. If there is a different type of silicon mold mix I should be using? I've lost two batches of molds and the parts are shot, need to order more.

Any help would be good. Thanks!

Cero.
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:3D Rendering of stainless steel texture
Next Topic:Small Batch Manufacturing
Goto Forum:
   Go
Generate printable PDF   


Current Time: Wed May 22 04:20:23 UTC 2013