First timer, trying to make my design hollow - 3D Design on Shapeways Discussions about 3D Printing

Home » Support » 3D Design » First timer, trying to make my design hollow

First timer, trying to make my design hollow [message #53843] Mon, 10 September 2012 18:40 UTC

piranhamonkey
Messages: 7
Registered: September 2012
Go to my shop

Junior Member

So I have attached a 3D version of an object but I want to make the thing hollow to cut down on the cost. Am I even doing this the right way?

	First timer, trying to make my design hollow By: piranhamonkey on Mon, 10 September 2012 18:40 UTC
	Re: First timer, trying to make my design hollow By: Fredd on Tue, 11 September 2012 01:15 UTC
	Re: First timer, trying to make my design hollow By: piranhamonkey on Tue, 11 September 2012 12:10 UTC
	Re: First timer, trying to make my design hollow By: JACANT on Tue, 11 September 2012 20:29 UTC
	Re: First timer, trying to make my design hollow By: piranhamonkey on Tue, 11 September 2012 21:04 UTC
	Re: First timer, trying to make my design hollow By: Fredd on Tue, 11 September 2012 22:40 UTC
	Re: First timer, trying to make my design hollow By: piranhamonkey on Tue, 11 September 2012 22:44 UTC
	Re: First timer, trying to make my design hollow By: JACANT on Tue, 11 September 2012 23:28 UTC
	Re: First timer, trying to make my design hollow By: piranhamonkey on Wed, 12 September 2012 19:55 UTC
	Re: First timer, trying to make my design hollow By: stonysmith on Wed, 12 September 2012 23:07 UTC

Previous Topic:	Help with sizing
Next Topic:	Sizing help -Medical research purposes- New member-first timer

Goto Forum:

Current Time: Thu May 23 22:02:10 UTC 2013

Don't miss Shapeways Live