Home » Support » 3D Design » Orientation
Search Search  
Orientation [message #53730] Fri, 07 September 2012 08:36 UTC Go to previous message
avatar paulelderdesign is currently offline paulelderdesign
Messages: 40
Registered: August 2012
Go to my shop
Member
Hi guys

Not sure if this is the right place but I have a little problem. When exporting from 3DS Max as an OBJ and uploading to Shapeways I have the model front on but when it is uploaded the display is lying down, upside down or showing the wrong side. This is important as a lot of my work has detail I would like to showcase. The same problem goes for the 3d viewer the model is all out.

I probably missed something, am hoping I don't need to delete all my models and upload again Shocked

Regards

Paul
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Previous Topic:SS: Malleable or brittle?
Next Topic:SS minimum wall thickness
Goto Forum:
   Go
Generate printable PDF   


Current Time: Wed Jun 19 04:27:18 UTC 2013