Home » Support » 3D Design » Interlocking help.
Search Search  
Interlocking help. [message #52486] Sat, 11 August 2012 03:11 UTC Go to previous message
avatar ou_let  is currently offline ou_let
Messages: 1
Registered: July 2012
Go to my shop
Junior Member
I attached a picture of my model, i need to connect these 2 pieces together. Currently the edges would be completely adjacent if moved into place. How much does everyone think i should skim off. I'm thinking very little or perhaps none at all. Note, i want them to be able to stay attached.

thanks

  • Attachment: fishhelp.png
    (Size: 24.42KB, Downloaded 72 time(s))

[Updated on: Sat, 11 August 2012 03:12 UTC]

Read Message
Read Message
Read Message
Read Message
Previous Topic:Can't figure out why my design isn't available in Alumide
Next Topic:Need some help with Mathematica
Goto Forum:
   Go