| Centaur figure [message #54981] Sat, 06 October 2012 19:41 UTC |
 |
|
]Hello, It has been a while since being active on Shapeways, and can't believe the level of prints from just a few years ago. I have recently been helping people with their models and wanted to start uploading some of my own again. Here is a Centaur, 60mm in height. If anyone has any suggestions, or would like it at a specific height let me know. There is also a turntable on the Shapeways page. Hope you like it!
Best, mike
http://www.shapeways.com/model/727603/centaur-60mm.html
Attachment: shapeways.jpg
(Size: 121.16KB, Downloaded 299 time(s))
CGmodeling.com
|
|
|
| Re: Centaur figure [message #55080 is a reply to message #54981 ] Tue, 09 October 2012 11:26 UTC |
 |
|
I'm really impressed by your talent as a sculptor ...wonderful.
KIORO'design
|
|
|
| Re: Centaur figure [message #55136 is a reply to message #55080 ] Wed, 10 October 2012 14:03 UTC |
|
|
Thanks Kiorodesign, hopefully people will enjoy it!
CGmodeling.com
|
|
|
| Re: Centaur figure [message #55268 is a reply to message #54981 ] Fri, 12 October 2012 17:34 UTC |
|
|
Yes, wonderful job. ZBrush, I assume? I'm always surprised I don't see more people from the ZBrush forums here on Shapeways.
Glenn
Glenn ------ My Website Third Dimension Jewellery
|
|
|
| Re: Centaur figure [message #55545 is a reply to message #55268 ] Thu, 18 October 2012 02:41 UTC |
|
|
Thanks Glenn!
Yes it's zbrush work, I have also wondered why there isnt more here on Shapeways. Probably just depends on the figurine market here, I am not sure.
CGmodeling.com
|
|
|
| Re: Centaur figure [message #55841 is a reply to message #55545 ] Wed, 24 October 2012 05:13 UTC |
|
|
That is really amazing. What kind of material are you going to use on that? I love it.
~Emily~
|
|
|
Search
