Home » Community » It arrived! » Stainless Steel pushed to limit
Search Search  
Stainless Steel pushed to limit [message #48457] Tue, 15 May 2012 16:47 UTC Go to previous message
avatar lensman is currently offline lensman
Messages: 1225
Registered: December 2009
Go to my shop
Senior Member
I was recently commissioned to produce a pendant for a clothing company and came up with the below. I had it printed in stainless steel and (inadvertantly!) pushed the limits of s/steel printing regarding the text areas... Sorry, but I didn't take a before picture; the pendant arrived with all kinds of what seemed to be organic "bits" jammed into the lettering which I had to dig out with a superfine needle point, and then I polished the front and back with a Dremel.

While I certainly wouldn't deliberately design the lettering this size again I'm quite happy that it printed almost 100% correctly. The pendant is 2" in height.

Glenn

index.php?t=getfile&id=16919&private=0

Glenn ------ My Website Third Dimension Jewellery
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Previous Topic:3x3 cm Pendants in Silver and FUD
Next Topic:Nested Silver Polyhedra
Goto Forum:
   Go
Generate printable PDF   


Current Time: Wed Jun 19 21:39:20 UTC 2013