Home » Support » 3D Design » Min void vs Min thk?
Search Search  
Min void vs Min thk? [message #45873] Fri, 23 March 2012 16:37 UTC Go to previous message
avatar Greek2Me is currently offline Greek2Me
Messages: 8
Registered: December 2009
Go to my shop
Junior Member
I'm working on a pendant that has lettering on it. My first attempt was raised lettering, but then I decided to try subtracting the letters instead (partly to lower the volume and hence, the cost). The model was rejected (see attached) citing a minimum opening as the cause. Is this roughly comparable to the minimum thickeness of any given material or is there some other value for a gap that prevents adjacent material from fusing back together?

Loving the products I have received so far, by the way...

Thanks

RMc

Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Very basic newbie question - don't shoot me.
Next Topic:nodes and rods (network) structure
Goto Forum:
   Go
Generate printable PDF   


Current Time: Tue Jun 18 22:26:40 UTC 2013