Home » Community » It arrived! » Roll-Back Racer
Search Search  
Roll-Back Racer [message #3630] Mon, 30 March 2009 02:17 UTC Go to previous message
avatar jdavidbush is currently offline jdavidbush
Messages: 32
Registered: November 2008
Go to all my models
Member
Hi Shapies!

I wanted to share with you the success (and failure) I've had so far printing the Roll-Back Racer (similar to the car in this blog).

Let me mention, this is the second printing of the car. Unfortunately, the first car had a few problems as the gears in the middle were fused to the axle and the entire right side of the spring was fused to its housing. I made some minor changes and then uploaded/printed it again.

Here is the new model!
http://kilbit.com/IMG_4326_3.jpg

I modeled the car to fit pre-existing rubber L*GO tires (and it fits either thin low-profile tires or thick off-road tires).
http://kilbit.com/IMG_4349_3.jpg

And, here it is without its tires. It looks kinda naked without them.
http://kilbit.com/IMG_4339_3.jpg

[Updated on: Mon, 30 March 2009 04:20 UTC]

Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:First Shapeways Order
Next Topic:Miniature test
Goto Forum:
   Go
Generate printable PDF   


Current Time: Fri May 24 10:06:46 UTC 2013