Home » Community » General Discussion »

Thoughts on 3D Scanners

Search Search  
Thoughts on 3D Scanners [message #61281] Sun, 03 February 2013 20:25 UTC Go to previous message
avatar JaceLightning  is currently offline JaceLightning
Messages: 0
Registered: February 2013
Go to all my models
Junior Member

3D Scanners[ 5 vote(s) ]
1.Own one and love it 1 / 20%
2.Own one but never use it 1 / 20%
3.123D and Dave 3D are good enough for me 0 / 0%
4.Would own one, but they are two exspensive 2 / 40%
5.Would own one, but scanning requires too much manual work 1 / 20%
6.Would own one, but they only scan outside features, and not inner features like gears/electronics 0 / 0%
7.I just enjoy printing and not designing 0 / 0%

Hey guys. Just trying to get feedback on 3D scanners. Do they work? Do you like them?

I know some require a lot of manual setup and work, like filling in holes, rotating the object by hand. Most require the object to be reflective and detailed, i.e. if the object is black, shinny, or has no features, it might be hard for the program to reconstruct the geometry.

3D scanners are great for shapes that are convex, but what about shapes with deep holes? or what about seeing inside the object? Wouldn't it be nice to scan an assembled object and then print a copy assembled?

Read Message
Read Message
Read Message
Previous Topic:Flexibility of WSF
Next Topic:Community Journal #2 Published
Goto Forum:



We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.