Home » Community » General Discussion » Material suitable for fuel/petrol/gasoline - i.e. carb manifold?
Search Search  
Material suitable for fuel/petrol/gasoline - i.e. carb manifold? [message #58674] Sun, 16 December 2012 02:27 UTC Go to previous message
avatar internetscooter is currently offline internetscooter
Messages: 3
Registered: December 2012
Go to all my models
Junior Member
Hi,

(Note: ignore other duplicates, answer this one - the system told me the posts failed to submit but obviously the had Crying or Very Sad )

I need to make a carb manifold and I am wondering if Alumide or some other material would work. I am concerned about it not being tolerant to the petrol in the air/fuel mixture. I have initial choosen Alumide because the manifold sits on the cyclinder head and would need to withstand ~100C without too much trouble.

Cheers,

Paul

[Updated on: Sun, 16 December 2012 02:59 UTC]

Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Previous Topic:I don't think a whole lot of UPS.
Next Topic:Batarang
Goto Forum:
   Go
Generate printable PDF   


Current Time: Thu May 23 17:29:21 UTC 2013