Home » Community » Work in progress »

A few ornament designs

Search Search  
A few ornament designs [message #58259] Sat, 08 December 2012 21:43 UTC Go to previous message
avatar bluelinegecko  is currently offline bluelinegecko
Messages: 98
Registered: February 2011
Go to my shop
Modeled these up over the last few weeks. Comments/ideas/feedback is very welcome.

Wasn't sure really what to call this one.. The base shape I started with was similar to a mobiuos strip. I was thinking mobious tree, but settled on "swirl tree" as a simpler name. There is some banding that shows up in the renders along the outer edge that i haven't been able to get rid of, but it is very slight and below the level of detail for the printers so it shouldn't sow up in the final product. This one should look best in polished strong and flexible. The top piece where a hook attaches is separate and designed to allow the piece to turn. Might also make a good outdoor decoration if it spins freely in the wind.



  • Attachment: ornament.png
    (Size: 69.06KB, Downloaded 176 time(s))

Read Message
Read Message
Read Message
Read Message
Previous Topic:a Bow design (for on top of presents)
Next Topic:Captured Snowflake Ornament
Goto Forum:



We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.