Home » Support » 3D Design » Turn engraving into a hole
Search Search  
Turn engraving into a hole [message #57018] Sun, 18 November 2012 09:09 UTC Go to previous message
avatar a3333326 is currently offline a3333326
Messages: 5
Registered: September 2012
Go to all my models
Junior Member
Hi,

I was wondering is it possible to turn an engraving into a hole? Such that it not just an engrave on a ring but something like an extraction.

Thank you very much.

Regards,
Wade
Report message to a moderator
Message index

Read Message
Read Message
Previous Topic:Ring design
Next Topic:I can't seem to get the right scale / 3ds max
Goto Forum:
   Go
Generate printable PDF   


Current Time: Thu May 23 17:57:27 UTC 2013