Home » Community » General Discussion » Wall Thickness Help Using Blender
Search Search  
Wall Thickness Help Using Blender [message #56256] Sat, 03 November 2012 13:28 UTC Go to previous message
avatar Swavek is currently offline Swavek
Messages: 13
Registered: June 2012
Go to my shop
Junior Member
After months of working in Blender I'm finally getting the modeling and scaling down, but not so with wall thickness. The solidify modifier is a convenient automatic tool to make wall thickness. But I'm not sure if it actually represents the same number that is optimal for 3D printing minimum thickness of ".07mm", ie. If I type in ".07" in the setting, does that really correspond with .07 mm thickness if I upload stating I'm using mm units? Any light on this is appreciated. Thanks.
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Choices of Material for Chopsticks
Next Topic:Back to sender...
Goto Forum:
   Go
Generate printable PDF   


Current Time: Wed May 22 04:33:33 UTC 2013