One Leg that clips on the circuit board for the Raspberry Pi Computer

This is a pair of legs to hold the Raspberry Pi Computer. They will flex slightly to firmly grab the PCBA. I have a wood desk and it has many scratches from having an assembled circuit board sliding around on it.

These 4 parts will allow you to hold the Raspberry Pi computer between a computer monitor and a mount or stand using the VESA 75 or VESA 100 mounting hole pattern found on most computer monitors. You will need some M3 or M4 screws that are 30 or 35 mm long to pass through the mount or stand and this part and into the monitor.

These is a pair of clips to hold the Raspberry Pi computer. They can be screwed down or screwed into.

This is one half of a case for the Raspberry Pi Computer. This is the bottom or base. This part is untested, since I do not have a Raspberry Pi computer yet. This case was designed to be made from 20ga steel I just uploaded it here for fun!