Screw two screws aligned on the horizon and just pop Moustache Coat Hanger on it! Two M4x14mm screws with a round head are recommended.
It will only be manufactured upon your request, made in the future! Moustache Coat Hanger consists of one solid piece, and is specifically not hollow to achieve maximum strength.
This piece may also be used as an cabinet handle or knob.
-two M4x14mm button/dome head screws (not included)
advised screw dimensions:
thread size: 4.0mm
head diameter: 7.8mm
head height: 3.0mm
These dimensions are of the screws shown in the last photo. Advised (minimum) screw length for application on wood: 14mm.
M4x14mm screws with a round head are recommended. However, many other types of screws including flat heads and sunk heads work.
One for one, push both screws into the Moustache. Use the flat end of a screwdriver to tuck the screws in all the way down. Make sure they fit snugly and are aligned. Now press the screws onto your plank/wall for screw markings. Remove both screws and screw them in the markings. Screws should protrude 5mm, and be 28.1mm apart. Now you can pop Moustache Coat Hanger on it.
Recommended to be used with coat hangers or the loop attached to the collar of the particular garment. Due to the nature of the design, the extremity of the mustache has an edge which may put pressure on jacket lining, especially if the garment is heavy. This is why i recommend coat hangers (which also keep your clothes in better shape ofcourse) or collar loops. I honestly don't expect this issue, but better safe than sorry :)
Want to get the 'stache set? +