Base tip for the Star Wand. I made it in half to save on cost as I will be molding and casting two halves for the final replica. Naturally, if you're not inclined to go through that process you can order two to make the complete piece.

Special Shell that fits my Caster Gun

Head piece for the Star Wand. I made it in half to save on cost as I will be molding and casting two halves for the final replica. Naturally, if you're not inclined to go through that process you can order two to make the complete piece.

Collar for the scabbard of Mekki-Maru. I made it in half to save on cost as I will be molding and casting two halves for the final replica. Naturally, if you're not inclined to go through that process you can order two to make the complete collar.

End plate for the scabbard of Mekki-Maru. I made it in half to save on cost as I will be molding and casting two halves for the final replica. Naturally, if you're not inclined to go through that process you can order two to make the complete tip.

This is the ornament on the scabbard of Mekki-Maru. It is intended that you cut the shapes from the platform or mold and cast in resin. The platform legs were added to meet Shapeways minimum height requirement.

Pommel of Mekki-Maru. I made it in half to save on cost as I will be molding and casting two halves for the final replica. Naturally, if you're not inclined to go through that process you can order two to make the complete pommel. I would suggest filling the inside with resin or epoxy putty for added strength.

End plate for the scabbard of Rekki-Maru. I made it in half to save on cost as I will be molding and casting two halves for the final replica. Naturally, if you're not inclined to go through that process you can order two to make the complete tip.

Plate at the base of the sword blades. One goes on each side. There wasn't much detail in the screen caps other than some indication of decoration. This is my interpretation of the detail.

Collar for the scabbard of Rekki-Maru. I made it in half to save on cost as I will be molding and casting two halves for the final replica. Naturally, if you're not inclined to go through that process you can order two to make the complete collar.

Lion-shaped plate that goes on each side of Rekki-Maru's scabbard. I made it in hollow to save on cost as I will be molding and casting two of them for the final replica. Naturally, if you're not inclined to go through that process you can order two for each side of the scabbard. I would suggest filling the inside with resin or epoxy putty for added strength.

This is a metal ring between the grip and the blade of Rekki-Maru. I made it in half to save on cost as I will be molding and casting two halves for the final replica. Naturally, if you're not inclined to go through that process you can order two to make the complete ring.