Dual Headed Eagle Shoulder Pads (x2)

Dual Headed Eagle Shoulder Pads (x2) 3d printed Miniatures SciFi
Check out my blog: http://dynath40k.blogspot.com/ In future a shelled version for printing in FUD, possibly a 10 up set, maybe removal or revision of the long wing plates. A pair of two headed eagle shoulder pads designed for my Legio-Custodes project. They are ideal for officers so I've put them out in a pair to start. If the test prints go well I'll produce a x5 up squad set. I'm worried that the beak and talons will have a wall thickness error on WSF but it will definitely print in FUD. The thin plastic rods are a feather fringe that mounts under the shoulder pad dropping down low to cover the arms as a decorative element. They are segmented so you can cut them apart and position them to match the figure's pose. It was an element i thought up that I've wanted to do for a while so I added it to this design as it fit it so well.
cm: 4.334 w x 2.102 d x 1.244 h
in: 1.706 w x 0.828 d x 0.49 h

Comments

 
 
  • Frosted Detail

    Matte translucent plastic with fine print lines that reveals small details.

    $8.91

Favorited by