Home » Community » It arrived! » Strawberries
Search Search  
Strawberries [message #57943] Tue, 04 December 2012 06:57 UTC Go to previous message
avatar AD-Edge is currently offline AD-Edge
Messages: 62
Registered: June 2008
Go to my shop
Member
My most recent order arrived the other day, so I thought Id share one of the prints from it. So here is the strawberry I had printed in Full Colour Sandstone. I think they turned out really well! (loving this material)

http://i.imgur.com/DQP93l.jpg


Took about 4 iterations to get the model right, turns out strawberries/fruit are quite difficult to get looking correct, I even went as far as to use the Fibonacci sequence to get it looking more 'natural' and to get the spacing/amounts of seeds correct and in the right 'pattern', tricky stuff, but it was a good challenge.
When the sun decides to come out in the coming days, I'm planning to gloss one to see how it turns out. Ive used spray-on gloss a few times on various FCS prints and it generally makes them look much better (not to mention protects them). Will make the strawberry print more shiny like a real strawberry as well, will post images here when its done.

Anyway, more images:

http://i.imgur.com/XdKWel.jpg

http://i.imgur.com/XA8ltl.jpg

Underside (upped the exposure to see the hollow inside, so the colour is out a bit)
http://i.imgur.com/6bMbZl.jpg

[Updated on: Tue, 04 December 2012 06:58 UTC]


Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:YingYang Soy Sauce Bowl in Ceramics
Next Topic:3D Wire Rhino Head
Goto Forum:
   Go
Generate printable PDF   


Current Time: Wed Jun 19 13:41:36 UTC 2013