Home » Community » Post Production Techniques » Making it less translucent
Search Search  
Making it less translucent [message #54648] Sun, 30 September 2012 02:35 UTC Go to previous message
avatar milosp  is currently offline milosp
Messages: 8
Registered: August 2012
Go to my shop
Junior Member
I have a head model printed in white detail material but since it is 1mm thick. I am thinking painting it inside with either white acrylic paint or with black printer refill ink . What do you think would be better solution in this case?


You can almost see my finger inside.


  • Attachment: sheldon3.JPG
    (Size: 65.94KB, Downloaded 204 time(s))

Read Message
Read Message
Read Message
Read Message
Previous Topic:Adverse effect of boiling water on WSF?
Next Topic:any technique to make a final good look for an iphone case in WSF? or in dyed colors?
Goto Forum: