Home » Community » 3D modeler needed » Paper Die
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Paper Die [message #59986] Thu, 10 January 2013 19:54 UTC Go to next message
avatar It_is_Finished  is currently offline It_is_Finished
Messages: 1
Registered: September 2012
Go to my shop
Junior Member
Is it possible to create a die to cut paper? very similar to a cookie cutter but sharper on the edges so when you press doun you punch a shape out of the paper.

Thank you in advance
Re: Paper Die [message #60018 is a reply to message #59986 ] Fri, 11 January 2013 08:50 UTC Go to previous message
avatar BAROBA  is currently offline BAROBA
Messages: 124
Registered: August 2008
Go to my shop
Senior Member
Both yes and no.
The edges would probably get deforned or break off during manufacturing and handling. You always need to have a small rounded edge to get a succesful print. But it is possible to sharpen those edges yourself afterwards.

Cheers,

Rob

 
   
Previous Topic:3D modeler needed to create necklace and bracelet
Next Topic:3D Modeler needed to create necklace and bracelet