| Superhero Mask Ring [message #39306] Sat, 26 November 2011 23:19 UTC |
|
|
I modelled this ring loosely based on the Green Hornet mask, which is, in essence, just a generic superhero mask anyway, to ultimately get it printed in silver.
I do like the silver material, I just wish Shapeways would allow for, say, two separate models to be printed in one file (as long as they were the same model, perhaps?). Yes, I know this can be done with earring and cufflinks, but when it comes to having to re-sell these items paying $74 for one ring just does NOT make it affordable - and that's without any profit. I was just yesterday charged $17.97 by UPS at the door and on top of the $6.50 I have to pay Shapeways. If I could spread that cost over two rings it at least becomes somewhat more bearable.
Glenn
[Updated on: Sun, 27 November 2011 01:41 UTC]
Glenn ------ My Website Third Dimension Jewellery
|
|
|
Search
