nitrocharged
I have been working with Micro EDF Jets for many years, developing smaller and faster power systems for them. I focus mainly on 30mm EDF's.
Expertise:
- Maker
by
nitrocharged
This is a 25mm ID EDF case designed to hold an 8.5mm diameter motor. There are no mounting holes on this as it is assumed the motor used will be a ...
by
nitrocharged
This can be a drop in replacement for the 28mm EDF about to come onto the market. This fan unit will allow you to mount a 12mm inrunner allowing f...
by
nitrocharged
This 30mm EDF case is designed for speed set ups. The 4 stator vane configuration allows a 3 blade rotor to work at maximum efficiency. The motor m...
by
nitrocharged
A 25mm Flanged EDF case suited for 10mm diameter inrunner motors.
by
nitrocharged
This is a 20mm EDF case to suit 10mm inrunner motors. The ID will allow a 20mm rotor to fit. Case wall is 0.8mm thick. Mounting holes are standard ...
by
nitrocharged
This is a spilt nacelle unit for 25mm EDF with 1/16" (1.6mm) slotted side mount. This allows you to mount the unit on a 1/16" ply piece and run you...
by
nitrocharged
This 30mm EDF case is designed for speed set ups. The 4 stator vane configuration allows a 3 blade rotor to work at maximum efficiency. The motor m...
by
nitrocharged
Team30 Micro EDF's 30mm EDF Nacelle for pod mounted ducted fans. The nacelle has guides to perfectly align the edf case into the unit. It also has ...
by
nitrocharged
This is a 25mm ID EDF case to suit 12mm inrunners. It has 4 stator vanes so would be suited for 3 and 5 blade rotors. It has 4 mounting holes in th...
by
nitrocharged
This is a 60mm diameter, 26 blade rotor designed after the pegasus fan. It is intended to supply a bucket load of static thrust. If purchasing this...
by
nitrocharged
A 30mm EDF two part nacelle/pod designed to make motor installation and maintenance easy.
by
nitrocharged
This is a removable EDF25mm case specifically designed for my 25mm EDF Micro Hawk. The design allows you to glue in the retaining assembly to the ...
