The Destroyer Chassis Part 1 of 2 (3)

The Destroyer Chassis is built to be MHS compatible with an OD 1.24" (main body) and pommel lips similar to MHS system from TCSS
**** this is NOT MHS approved or TCSS approved **** 
*** the chassis can be used with or without a crystal chamber ***
** see highlighted links for extra products related to this chassis ** 

--------chassis specification:--------
chassis total length including crystal chamber 6.525" without the crystal chamber 4.365"
built to hold Prizm 5.1 soundboard.
built in place for Li-Ion 18650 3.7V battery.
built in place for a 28mm bass speaker.
built in place for Switchcraft 2.1mm Power Jack
inner holes for wiring.
a cover cap for the soundboard

--------Crystal chamber specification:--------
Crystal chamber is made from three parts, 2x LED holders, and chamber body 
** Crystal chamber is a separate  preaches **

• crystal chamber has a built holes for two 5mm LED to light the crystal.
• crystal chamber built for a 1.5" long and 0.42" thick crystal.
• 3D printed crystal is available in my store: The Destroyer crystal 
• to hold the crystal chamber with the chassis you will need: 
  • six 2.8mm (0.114") solid brass rods, length will vary (depends on your built).

1. three will go thru the crystal chamber and thru most of the chassis
2. three will go thru the crystal chamber and a small part of the chassis. link: solid rods  

• 3mm led holders are available for eight 3mm led's (you will need to buy x4 each holder holds two LED)

* printing in metal can have ± 0.125mm change in size
** Chassis have a small place for resistors, a professional installer is recommended
*** some minor modification may be needed (printing can shrink the rods holes by 0.1mm or less)