JaBird RC Dual Servo Plate

Mounts to the JaBird RC carbon fiber chassis rails.  If you mount this dual servo palte to the Forward Motor setup you will be limited to use of a motor can length.  We have tested fitment with HH CrawlMaster Pro, and the HH Team Puller 500, both brushed motors.  Most crawler type out-runner motors work very well.  We cannot know if this fits with all chassis or motors.

V2 Panhard Mount PA12 required: https://www.shapeways.com/product/Y5S4KZZ8H/v2-panhard-mount-pa12?optionId=114497102

***Do NOT use the rubber or brass harwardware that is funished with your servo.  If your servo is plastic remove the gussets as the servo needs to mount flat to the servo plate***

Be sure to clean out the holes.  Hand drill only: use a 3/32" drill in the two small holes and 1/8" drill in the front (F) larger holes.  Use six (6) M3 nylon lock nuts and 3mm screws.  The two rear servo mounting holes require at least two (2) 12mm long screws.  Also, use washers on the plastic side for the servo and winch.