FTI Radiolarian 3 - face turning icosahedron

  • White

    White nylon plastic with a matte finish and slight grainy feel.

    $299.50

This is the third in my series of face-turning icosahedra, the Radiolarians. The series is named after a small ameboid protozoa that can produce a skeleton in this shape.

The first straight cut face turning icosahedron in the world was my "Radiolarian 2", which has slightly shallower cuts. This puzzle, the "Radiolarian 3", was the follow up with deeper cuts which add a part in the center of each face.

You will receive a DIY kit of raw 3d printed parts. You will need to provide your own 4-40 size screws, washers and springs to assemble your puzzle. I prefer this puzzle without springs. Stickers can be obtained by emailing stickers@puzzleforge.com for 8 dollars plus shipping.

Dimensions

IN: 5.113 w x 5.113 d x 5.113 h
CM: 12.988 w x 12.762 d x 14.694 h

Comments

 
@youryeekbubby I don't offer that service, but there may be some folks willing to do this for you if you are a member on the twistypuzzles.com forums. Are you?
February 2, 2014, 8:28 pm
@PuzzleForge How much is this puzzle fully assembled in polished dyed black and fully stickered?
February 2, 2014, 3:11 pm
How much is this puzzle fully assembled in polished dyed black and fully stickered?
February 2, 2014, 3:09 pm
@youryeekbubby You will need 20 screws, but it's always good to have a few extras on hand.
February 2, 2014, 3:36 am
@PuzzleForge how many screws do I need for this puzzle?
February 1, 2014, 11:05 pm