Iphone 5 Bumper Case Prototype

Iphone 5 Bumper Case Prototype 3d printed Accessories Gadgets
This case is a prototype case for the Iphone 5, offered at cost for the time being to check the fit around the outside. I've since been told that the case is slightly too small and needs to be heated to fit over the phone, resulting in small case cracks when it cools. Ive asked for a couple of images of the damaged case and a case redesign to remove these flaws is planned.
cm: 6.056 w x 12.582 d x 0.96 h
in: 2.384 w x 4.954 d x 0.378 h

Comments

 
Unfortunately not. But if you like you can buy one and if it doesnt fit I'll gladly refund your cash - or you could wait a couple of days until I upload a new set of cases that should bypass any fitting issues entirely. :)
November 14, 2012, 3:19 pm
Any word on the fit? This is the case I've been wanting for my 5...
November 11, 2012, 10:25 pm
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $7.20

Favorited by