Enabler Cube

Enabler Cube 3d printed Art Puzzles
Enabler Cube was suggested in a discussion at the Twisty Puzzles Forum. It acts like a Rubik's Cube with blocked layers. Only three layers can turn, i.e. those in which the rounded "enabler" cubie resides. Specialists may call this type of turning "deeper-than-deep cut". This puzzle is sort-of the opposite of Fused Cube, where the three layers of the special corner cubie cannot turn.

This puzzle was inspired by a similar design by Evgeniy Grigoriev with an unlocking edge instead of an unlocking corner, and a comment by Bram Cohen.

Watch the YouTube video.
Read at the Shapeways Forum.
Read more at the Twisty Puzzles Forum.

Please contact Oskar directly if you are interested in obtaining a fully colored, stickered and assembled sample of this puzzle.

cm: 15.5 w x 5.964 d x 6.744 h
in: 6.102 w x 2.348 d x 2.655 h

Comments

 
It isn't all the way done because I haven't gotten the screws for it
April 11, 2014, 2:05 am
Hey Oskar I just ordered this and it is suppose to get here tomorrow and I was wandering if you could show make a link on instructions on how t put it together
April 9, 2014, 3:23 am
 
  • White Strong & Flexible

    White nylon plastic with a matte finish and slight grainy feel.

    $162.96

Favorited by