Right from the laboratory.

Part to be used as support for the light foam wheel. - part of the quadcopter frame (under development)

Finally the official release of the SkyLight SBG Digital Brushless Gimbal for GoPro Hero 2 HD Cameras!! Designed for the AlexMos SImple Brushless ...

Part of a wire leg for a multirotor. Each leg needs two hinges. It is held to 1/2" (13mm) square arm with two zip ties. The hinge either holds the ...

4 required for whole assembly This is the second bone, the middle, finger bone (not middle-finger bone), for all four fingers, including the pinky.

4 required for whole assembly This is the tip of the fingers, not the thumb, of the bob

Landing gear for light Quadrocopters. For standard 10x10mm beams

for servo "Modelcraft ES-05"

Ten (10) tooth XL belt pulley for use with stepper motors with a 5mm shaft. Great for driving x and y axis belts on a Prusa or other RepRap 3d pri...

3 required for whole assembly This is the first bone, just off the knuckle, for the pointer finger, the middle finger, and the ring finger. That wo...

One cross arm and two hinges and 3/32 wire make a single multirotor leg. Inspired by legs on Aerovironment Qube.

2 required for whole assembly This is the knuckle-joint for the middle, two fingers of the bob

motor mount for gimble.

Maxbotix sonar mount for RC helicopter with 19mm diameter tail boom Not yet tested (but it's probably fine)

Mold for soft robot from this project on Instructables: http://www.instructables.com/id/Air-Powered-Soft-Robotic-Gripper/. Be sure to order materia...

Open Source 2 Axis Brushless Gimbal for the AlexMos Brushless Gimbal Controller. BETA v1.09

Compass mount for tail of Trex450 This has not been tested yet. I might eventually combine the compass mount with the sonar mount.

Motor mount for an automated Etch-a-Sketch

1 required for whole assembly This is the index finger, or pointer finger, or 1st finger, knuckle-joint of the bob

1 required for whole assembly This is the 'wrist' of the bob

1 required for whole assembly This is the tip of the thumb of the bob

1 required for whole assembly This is the middle, thumb bone on the bob

1 required for whole assembly This is the pinky-knuckle joint of the bob

1 required for whole assembly This is the half of the palm that supports the pinky and the 3rd finger of the bob

1 required for whole assembly This is the 'saddle joint' of the thumb that gets installed into the palm

1 required for whole assembly This is the first bone of the pinky, just off the pinky knuckle

1 required for whole assembly This is the bottom, thumb, long-bone just attached to the saddle joint

4x 6-Tooth High Strength Sprocket

1 required for whole assembly This is the 1st half of the palm that supports the thumb and the 1st, two digits of the bob

See description and license at: http://www.thingiverse.com/thing:63471

Once purchased, you will receive instructions with material needed for building a working rotocopter. I will give you tech support through the pro...

Door Stand for MAE 416 NCSU Senior Design Project