Home » Community » It arrived! » Snake Eating Tail Pendant / Earrings
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Snake Eating Tail Pendant / Earrings [message #48944] Fri, 25 May 2012 21:51 UTC Go to next message
avatar lensman is currently offline lensman
Messages: 1192
Registered: December 2009
Go to my shop
Senior Member
I was commissioned to make these silver earrings but in retrospect I feel they make for a decent pendant due to the fact that each weighs 53 grams! 3 inches in width.

(Note that model page still shows the earrings until Shapeways gets their "little" bug fixed re model upload preview not updating).

Model page link.

index.php?t=getfile&id=17188&private=0

[Updated on: Fri, 25 May 2012 21:52 UTC]

Glenn ------ My Website Third Dimension Jewellery
Report message to a moderator
Re: Snake Eating Tail Pendant / Earrings [message #49883 is a reply to message #48944 ] Fri, 15 June 2012 17:56 UTC Go to previous messageGo to next message
avatar carine is currently offline carine
Messages: 60
Registered: August 2011
Go to my shop
Member
I work here
well done! any plans to make a ring? ideally one that goes across two fingers? Wink
Report message to a moderator
Re: Snake Eating Tail Pendant / Earrings [message #49900 is a reply to message #48944 ] Fri, 15 June 2012 23:33 UTC Go to previous message
avatar lensman is currently offline lensman
Messages: 1192
Registered: December 2009
Go to my shop
Senior Member
Hhm... you mean a circle sitting on top of the two fingers?

Glenn

Glenn ------ My Website Third Dimension Jewellery
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:Kaleidoscope Clock
Next Topic:Portal 2 - Atlas co-op bot