I have this inner curve that must be made this way. Because it has a 360 degree support can less than 3mm thickness be OK here. It gets flagged for being less than 3mm thickness. I can't design it any other way. It has to taper to the edge. It tapers to 0.025"...can this be done or what is the minimum that can done? If not then I can't make this part.
how big this model should be? When i open it i see model that is 1,27mm wide. Did you use correct units during uploading it?
oh yeah....it's straight out of AutoCad so dimensions would be off. The outside diameter is 1.25" ... inside diameter is 0.7"