Gun barrel weight \ underlug needed

Approximately 6inch long weight needed to be modeled to be added under a revolver pistol barrel. must be precise measurements. can send barrel to model off of.

Sorry, i just realized a 6 inch long piece would be $300+ in stainless steel, so i am cancelling this project.

can be machined on CNC for much less

do you have any suggestions for where to get this single item CNCd? thanks!

you might look into finding a local gunsmith. they would likely have all the tools needed for such a project

Yeah, a gunsmith is highly advised, not just for cost/experience reasons, but also safety.